Debug Vqpc - Cisco Catalyst 3560-X Command Reference Manual

debug vqpc

debug vqpc
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
B-104
Downloaded from www.Manualslib.com
Use the debug vqpc privileged EXEC command to enable debugging of the VLAN Query Protocol
(VQP) client. Use the no form of this command to disable debugging.
debug vqpc [all | cli | events | learn | packet]
no debug vqpc [all | cli | events | learn | packet]
all (Optional) Display all VQP client debug messages.
cli (Optional) Display the VQP client command-line interface (CLI) debug
messages.
events (Optional) Display VQP client event debug messages.
learn (Optional) Display VQP client address learning debug messages.
packet (Optional) Display VQP client packet information debug messages.
Debugging is disabled.
Privileged EXEC
Release Modification
12.2(53)SE2 This command was introduced.
The undebug vqpc command is the same as the no debug vqpc command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Command Description
show debugging Displays information about the types of debugging that are enabled.
manuals search engine
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02