Stack-Power - Cisco Catalyst 3560-X Command Reference Manual

stack-power

stack-power
Note
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Catalyst 3750-X and 3560-X Switch Command Reference
2-854
Downloaded from www.Manualslib.com
To configure StackPower parameters for the power stack or for a switch in the power stack, use the stack
power global configuration command. To return to the default setting, use the no form of the command,
stack-power {stack power stack name | switch switch-number}
no stack-power {stack-id name | switch switch-number}
This command is available only on Catalyst 3750-X switch stacks running the IP base or IP services
image.
stack power stack name Enter the power stack name. The name can be up to 31 characters. Entering
these keywords followed by a carriage return puts you in power stack
configuration mode.
switch switch-number Enter the switch number in the stack (1 to 4) to enter switch stack-power
configuration mode for the switch.
There is no default.
Global configuration
Release Modification
12.2(53)SE2 This command was introduced.
When you enter the stack-power stack power stack name command, you enter power stack
configuration mode, and these commands are available:
• default: returns a command to its default setting.
exit: exits ARP access-list configuration mode.
•
mode: sets the power mode for the power stack. See the
•
no: negates a command or returns to default settings.
•
If you enter the stack-power switch switch-number command with a switch number that is not
participating in stack power, you receive an error message.
When you enter the stack-power switch switch-number command with the number of a switch
participating in stack power, you enter switch stack power configuration mode, and these commands are
available:
default: returns a command to its default setting.
•
exit: exits switch stack power configuration mode.
•
• no: negates a command or returns to default settings.
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
mode command.
OL-21522-02