Network-Policy Profile (Network-Policy Configuration) - Cisco Catalyst 3560-X Command Reference Manual

network-policy profile (network-policy configuration)

network-policy profile (network-policy configuration)
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Catalyst 3750-X and 3560-X Switch Command Reference
2-416
Downloaded from www.Manualslib.com
Use the network-policy profile configuration mode command to configure the network-policy profile
created by using the network-policy profile global configuration command. Use the no form of this
command without additional parameters to delete a profile. Use the no form with parameters to change
its configured attributes.
network-policy profile profile number {voice | voice-signaling} vlan [vlan-id {cos cvalue | dscp
dvalue}] | [[dot1p {cos cvalue | dscp dvalue}] | none | untagged]
no network-policy profile profile number {voice | voice-signaling} vlan [vlan-id | {cos cvalue} |
{dscp dvalue}] | [[dot1p {cos cvalue} | {dscp dvalue}] | none | untagged]
voice
voice-signaling
vlan
vlan-id
cos cvalue
dscp dvalue
dot1p
none
untagged
No network policies are defined.
Network-policy configuration
Release Modification
12.2(53)SE2 This command was introduced.
Use the network-policy profile command to configure the attributes of a network-policy profile.
The voice application type is for dedicated IP telephones and similar devices that support interactive
voice services. These devices are typically deployed on a separate VLAN for ease of deployment and
enhanced security through isolation from data applications.
The voice-signaling application type is for network topologies that require a different policy for voice
signaling than for voice media. This application type should not be advertised if all the same network
policies apply as those advertised in the voice policy TLV.
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Specify the voice application type.
Specify the voice-signaling application type.
Specify the native VLAN for voice traffic.
(Optional) Specify the VLAN for voice traffic. The range is 1 to 4094.
(Optional) Specify the Layer 2 priority class of service (CoS) for the
configured VLAN. The range is 0 to 7; the default is 5.
(Optional) Specify the differentiated services code point (DSCP) value
for the configured VLAN. The range is 0 to 63; the default is 46.
(Optional) Configure the telephone to use IEEE 802.1p priority tagging
and to use VLAN 0 (the native VLAN).
(Optional) Do not instruct the IP telephone about the voice VLAN. The
telephone uses the configuration from the telephone key pad.
(Optional) Configure the telephone to send untagged voice traffic. This
is the default for the telephone.
OL-21522-02