Switchport Access - Cisco Catalyst 3560-X Command Reference Manual

switchport access

switchport access
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Catalyst 3750-X and 3560-X Switch Command Reference
2-868
Downloaded from www.Manualslib.com
Use the switchport access interface configuration command on the switch stack or on a standalone switch
to configure a port as a static-access or dynamic-access port. If the switchport mode is set to access, the
port operates as a member of the specified VLAN. If set to dynamic, the port starts discovery of VLAN
assignment based on the incoming packets it receives. Use the no form of this command to reset the
access mode to the default VLAN for the switch.
switchport access vlan {vlan-id | dynamic}
no switchport access vlan
vlan vlan-id Configure the interface as a static access port with the VLAN ID of the
access mode VLAN; the range is 1 to 4094.
vlan dynamic Specify that the access mode VLAN is dependent on the VLAN Membership
Policy Server (VMPS) protocol. The port is assigned to a VLAN based on
the source MAC address of a host (or hosts) connected to the port. The switch
sends every new MAC address received to the VMPS server to get the VLAN
name to which the dynamic-access port should be assigned. If the port
already has a VLAN assigned and the source has already been approved by
the VMPS, the switch forwards the packet to the VLAN.
The default access VLAN and trunk interface native VLAN is a default VLAN corresponding to the
platform or interface hardware.
A dynamic-access port is initially a member of no VLAN and receives its assignment based on the packet
it receives.
Interface configuration
Release Modification
12.2(53)SE2 This command was introduced.
The no switchport access command resets the access mode VLAN to the appropriate default VLAN for
the device.
The port must be in access mode before the switchport access vlan command can take effect.
An access port can be assigned to only one VLAN.
The VMPS server (such as a Catalyst 6000 series switch) must be configured before a port is configured
as dynamic.
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
OL-21522-02