Show Flowcontrol - Cisco Catalyst 3560-X Command Reference Manual

show flowcontrol

show flowcontrol
Syntax Description
Command Modes
Command History
Usage Guidelines
Catalyst 3750-X and 3560-X Switch Command Reference
2-584
Downloaded from www.Manualslib.com
Use the show flowcontrol user EXEC command to display the flow control status and statistics.
show flowcontrol [interface interface-id | module number] [ | {begin | exclude | include}
expression]
interface interface-id (Optional) Display the flow control status and statistics for a specific
interface.
module number (Optional) Display the flow control status and statistics for all interfaces on the
switch or specified stack member.
On Catalyst 3750-X switches, the range is 1 to 9.
On Catalyst 3560-X switches, the only valid module number is 1.
This option is not available if you have entered a specific interface ID.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
User EXEC
Release Modification
12.2(53)SE2 This command was introduced.
Use this command to display the flow control status and statistics on the switch or for a specific interface.
Use the show flowcontrol command to display information about all the switch interfaces. For a
standalone switch, the output from the show flowcontrol command is the same as the output from the
show flowcontrol module number command.
Use the show flowcontrol interface interface-id command to display information about a specific
interface.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
OL-21522-02