Debug Platform Resource-Manager - Cisco Catalyst 3560-X Command Reference Manual

debug platform resource-manager

debug platform resource-manager
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
B-70
Downloaded from www.Manualslib.com
Use the debug platform resource-manager privileged EXEC command to enable debugging of the
resource manager software. Use the no form of this command to disable debugging.
debug platform resource-manager {all | dm | erd | errors | madmed | sd | stats | vld}
no debug platform resource-manager {all | dm | erd | errors | madmed | sd | stats | vld}
all Display all resource manager debug messages.
dm Display destination-map debug messages.
erd Display equal-cost-route descriptor-table debug messages.
errors Display error debug messages.
madmed Display the MAC address descriptor table and multi-expansion descriptor table
debug messages.
sd Display the station descriptor table debug messages.
stats Display statistics debug messages.
vld Display the VLAN-list descriptor debug messages.
Debugging is disabled.
Privileged EXEC
Release Modification
12.2(53)SE2 This command was introduced.
The undebug platform resource-manager command is the same as the no debug platform
resource-manager command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Command Description
show debugging Displays information about the types of debugging that are enabled.
manuals search engine
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02