Dot1X Fallback - Cisco Catalyst 3560-X Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

dot1x fallback

Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
Related Commands
OL-21522-02
Downloaded from www.Manualslib.com
Use the dot1xfallback interface configuration command on the switch stack or on a standalone switch
to configure a port to use web authentication as a fallback method for clients that do not support
IEEE 802.1x authentication. To return to the default setting, use the no form of this command.
dot1x fallback fallback-profile
no dot1x fallback
fallback-profile Specify a fallback profile for clients that do not support IEEE 802.1x
authentication.
No fallback is enabled.
Interface configuration
Release Modification
12.2(53)SE2 This command was introduced.
You must enter the dot1x port-control auto interface configuration command on a switch port before
entering this command.
This example shows how to specify a fallback profile to a switch port that has been configured for
IEEE 802.1x authentication:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet1/0/3
Switch(config-if)# dot1x fallback profile1
Switch(config-fallback-profile)# exit
Switch(config)# end
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Command
show dot1x [interface interface-id]
fallback profile
ip admission
ip admission name proxy http
manuals search engine
Description
Displays IEEE 802.1x status for the specified port.
Create a web authentication fallback profile.
Enable web authentication on a port
Enable web authentication globally on a switch
Catalyst 3750-X and 3560-X Switch Command Reference
dot1x fallback
2-167