Omron NX701-17 Series User Manual page 50

2 Part Names and Slave Settings
 Communications Setup Dialog Box Settings
Item
Connection type
Remote IP Address
Options
Response Monitor
Time
2-8
Specify the connection method to use for online communications. The specified connec-
tion method is used when you go online.
If you select Remote connection via USB or Ethernet connection via a hub, set the IP
address of the Controller that you normally will connect to.
USB Communica- These buttons perform a communication test with the Controller
tions Test Button at the specified IP address. The result is displayed as follows:
Ethernet Communica- • Normal: "Test OK"
tions Test Button
• Error: "The Controller was not found." or "There is more than
one Controller with the specified IP address."
Confirm the serial ID If you select this option, the names and serial IDs are compared
when going online. between the project and the Controller when you go online to
make sure that a connection is made to the intended Controller.
Check forced refresh- If you select this option, a check is made to see if any forced
ing when going offline. refreshing values are still in effect before going offline.
You can set the response monitor time for communications with the Controller.
An error is displayed if a response is not received before this time expires.
Note The time can be set to between 1 and 3,600 s.
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)
Description