Omron NX701-17 Series User Manual page 191

Attached Attached information 1: Error location diagnostic result
information
Attached information 2: Node address of the slave which the frame from the slave that is connected to the output port
is not received. (Only if the attached information 1 is 1.)
Attached information 3: Port name of the slave output port which the frame from the slave that is connected is not
received. (Only if the attached information 1 is 1.)
Attached information 4: System information
Precautions/ If the node address setting of an EtherCAT slave is not made, the node address cannot be identified from the attached
Remarks information. Check that there is no error for each slave and cable.
*1 This event code occurs for unit version 1.11 or later of the CPU Unit.
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)
0: Error location is not identified
1: Error location is identified
0: Master
Not 0: Node address of the slave
• If the network configuration information agrees with the physical network information of the rele-
vant slave, the port name that is displayed on the Support Software is output. If they do not
agree, any one of PortA, PortB, PortC, and PortD is output as the default of a port name.
• If the attached information 2 is 0, 0 is output as the port name.
9 Troubleshooting
9-21
9