Omron NX701-17 Series User Manual page 214

9 Troubleshooting
Event name Errors Reset
Meaning A command was received to reset errors.
Source EtherCAT Master Function Module
Error attributes Level
Effects User program
Indicators EtherCAT NET RUN
---
System-defined Variable
variables
_EC_PDSlavTbl
_EC_MBXSlavTbl
Cause and Assumed cause
correction
An error reset operation was per-
formed from the Sysmac Studio.
The ResetECError instruction was
executed.
Attached None
information
Precautions/ None
Remarks
* "n" is 512 for an NX-series CPU Unit and 192 for an NJ-series CPU Unit.
9-44
Source details
Information Recovery
Continues. Operation
EtherCAT NET ERR
---
Data type
Array[1..n] of BOOL*
Array[1..n] of BOOL*
Correction
---
---
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)
Event code 94430000 hex
Master Detection
timing
--- Log category
Master:
The current errors are reset and the network is verified
again. If the error is not detected again, process data
communications with the slave for which communications
were stopped are restarted.
Slave:
The slave where the error occurred enters the Operational
state.
EtherCAT LINK/ACT
---
Name
Process Data Communicating Slave
Table
Message Communications Enabled
Slave Table
Prevention
---
---
When errors are
reset
System