Precautions; Interference During Training - Polar Electro M460 User Manual

When changing the battery, make sure the sealing ring is not damaged, in which case you should replace it with a new
one. You can purchase the sealing ring/battery kits at well-equipped Polar retailers and authorized Polar Services. In
the USA and Canada, the additional sealing rings are available at authorized Polar Service Centers. In the USA the seal-
ing ring/battery kits are also available at www.polar.com/us-en.
When handling a new, fully charged battery, avoid clasp-like contact, i.e. simultaneously from both sides, with metal or
electrically conducting tools, like tweezers. This may short circuit the battery, causing it to discharge more rapidly. Typ-
ically, short circuiting does not damage the battery, but it may decrease the capacity and the lifetime of the battery.
1. Lever the battery cover
open by using a small flat-
headed tool.
2. Remove the old battery
from the battery cover.
3. Insert the new battery
(CR2025) inside the cover
with the negative (-) side
outwards.
4. Align the ledge on the bat-
tery cover with the slot on
the connector and press
the battery cover back into
place. You should hear a
snap.
For safety reasons, please ensure you use the correct battery (CR2025).

PRECAUTIONS

The Polar M460 training device shows your performance indicators. The training device is designed to indicate the
level of physiological strain and recovery during and after an exercise session. It measures heart rate, speed and dis-
tance. It also measures cycling cadence when used with a cadence sensor and power output when used with power
sensors. No other use is intended or implied.
The training device should not be used for obtaining environmental measurements that require professional or indus-
trial precision.

INTERFERENCE DURING TRAINING

Electromagnetic Interference and Training Equipment
Disturbance may occur near electrical devices. Also WLAN base stations may cause interference when training with the
training device. To avoid erratic reading or misbehavior, move away from possible sources of disturbance.
Training equipment with electronic or electrical components such as LED displays, motors and electrical brakes may
cause interfering stray signals. To solve these problems, try the following:
68