Draytek Vigor3900 User Manual page 465

Vigor3900 Series User's Guide
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: (0)330 088 0195 Fax: +44 (0)1245 808299
HTTP Port
HTTPS Allow
HTTPS Port
Port
Username
Password
Polling Status
Polling Interval
Apply
Cancel
4 4 . . 1 1 6 6 . . 1 1 . . 2 2 V V P P N N G G e e n n e e r r a a
This page allows you to configure the basic settings for the VPN tunnel of Vigor3900.
Available parameters are listed as follows:
Item
WAN Profile
Local IP/Subnet
IPsec Security Method
Type a port number for HTTP. The default value is 8080.
Click Enable to activate the HTTPS setting.
Type a port number for HTTPS. The default value is 8443.
Type a port number for Vigor3900.
Type a username which will be used by any CPE tried to
connect to Vigor router.
Type a password which will be used by any CPE tried to
connect to Vigor router.
Enable – Click it to enable the polling function.
Disable – Click it to disable the polling function.
Type the time value (unit is second). The range is from 60 ~
86400.
Click it to save the configuration.
Click it to discard the settings configured in this page.
l l S S e e t t u u p p
Description
Choose a WAN interface profile to be used.
Type the IP address and subnet mask of local host.
Choose one of the following methods for the security of
data transmission. For example, choose AH to specify the
IPSec protocol for the Authentication Header protocol. The
data will be authenticated but not be encrypted.
457