Control-Plane - Cisco Catalyst 3650 series Command Reference Manual

control-plane

control-plane
control-plane { ip address| auth-key key}
Syntax Description
ip address
auth-key key
Command Default
None
Command Modes
Fabric-auto-domain configuration mode
Command History
Release
Cisco IOS XE Denali 16.3.1
Usage Guidelines
Use the command to configure the control-plane device IP address and the authentication key, to allow fabric
edge devices to communicate with the control-plane device.
This command auto-generates LISP configuration, to orchestrate the fabric overlay. The show-running
configuration command shows the fabric domain configuration including the auto-generated commands.
Examples The following configuration is auto-generated when this command is run on your device:
Device(config-fabric-auto-domain)#control-plane 2.2.2.2
auth_key examplekey123
router lisp
locator-set default.RLOC
ipv4-interface Loopback0 priority 10 weight 10
exit
disable-ttl-propagate
ipv4 sgt
eid-table default instance-id 0
exit
loc-reach-algorithm lsb-reports ignore
ipv4 itr map-resolver 2.2.2.2
ipv4 itr
ipv4 etr map-server 2.2.2.2 key examplekey123
ipv4 etr
For information about theipv4 map-server and ipv4 map-resolver commands, see
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
16
Configures the IP address of the
control-plane device.
Configures the key to authenticate
access to the control-plane device.
Modification
This command was introduced.
LISP Command Reference..