Mdc - Toshiba QOSMIO E10 Maintenance Manual

4.12 SD board/MDC

4.12.2 MDC

Removing the MDC
The following describes the procedure for removing the MDC (See Figure 4-23).
1. Turn over the SD board.
2. Remove the following screws fixing the MDC and pull the MDC straight up from the
connector PJ3000 on the SD board.
• M2×4Z
3. Remove the RJ11 harness from the MDC.
Installing the MDC
The following describes the procedure for installing an MDC (See Figure 4-23).
1. Connect the RJ11 harness to the MDC.
2. Connect the MDC to the connector PJ3000 on the SD board.
3. Secure the MDC with the following screws.
• M2×4Z
QOSMIO E10 Maintenance Manual (960-492)
BIND screw
MDC
PJ3000
Figure 4-23 Removing the MDC
BIND screw
4 Replacement Procedures
x2
M2×4Z BIND screw
RJ11 harness
x2
4-41