4.10 Touch pad
Installing the touch pad
The following describes the procedure for installing the touch pad (See Figure 4-19).
1. Stick the touch pad and secure it with the following screws.
•
NOTE: Do not reuse the touch pad so that it can not be used after peeling off from the
computer. Be sure to stick a new touch pad.
2. Install the touch pad plate and secure it with the following screws.
•
3. Connect the touch pad flat cable to the connector on the touch pad.
QOSMIO E10 Maintenance Manual (960-492)
M2.5×2.8B
FLAT BIND screw
M2.5×2.8B
FLAT BIND screw
4 Replacement Procedures
x2
x2
4-35