Toshiba QOSMIO E10 Maintenance Manual page 248

4 Replacement Procedures
M2.5x4B FLAT BIND
SD board flat cable
CN9500
Installing the SD board
The following describes the procedure for installing the SD board (See Figure 4-22).
1. Connect the SVP harness and SD board flat cable to the connectors PJ9551 and
CN9510 on the SD board.
2. Install the RJ11 connector and its core to the slot of the base assembly.
3. Connect the USB harness to the connector PJ4620 on the SD board.
4. Connect the speaker cable L (red cable) and speaker cable R (blue cable) to the
connectors PJ6002 and PJ6003 on the SD board.
5. Install the SD board and secure it with the following screws.
• M2.5×4B FLAT BIND screw
6. Connect the SVP harness to the connectors PJ5801 on the system board and PJ9615
on the TV board.
7. Connect the SD board flat cable to the connector CN9500 on the system board.
4-40
PJ5801
CN9500
PJ9551
PJ6002
PJ6003
Figure 4-22 Removing the SD board
4.12 SD board/MDC
PJ9615
Speaker cable L
Speaker cable R
USB harness
RJ11 connector
Core
PJ4620
x3
QOSMIO E10 Maintenance Manual (960-492)