Toshiba QOSMIO E10 Maintenance Manual page 79

2.4 System Board Troubleshooting
Table 2-6 Debug port (Resume mode) error status (2/4)
LED Status
F123h
Check of the checksum of conventional
memory
F124h
Initializing of PCI devices
Check of WakeUp factors after initializing
PCI bus
Waiting for initializing of devices which
F125h
have to be initialized before setting HW
by PnP resource
Recovery of each device (1)
Check of HDD pack connection
Start of IDE device resume sequence
F126h
Recovery of user alarm setting and
cancel of alarm power-on function
Enable of power-off switch
Initializing EC and start of reading battery
information
QOSMIO E10 Maintenance Manual (960-492)
Test item
2 Troubleshooting Procedures
Contents
Initializing of sound
Acquires the multi-box status.
Initializing of HC, recognizing of USB devices
connection and initializing the USB devices
Control of permission/prohibition for built-in LAN
Resume error 74H
Waiting for completion of MultiBox status check
Processing of RESUME for PnP
Tentative initialization of printer port
Serial interrupt control
Waiting for the completion of VGA power-down
control (because the VGA configuration can not
be seen)
Processing of RESUME for PCI
Recovery of FDC
Checks slots that were in ON status during
suspending ( for fingerprint identification)
Recovery of PCMCIA card
Error when an ATA card is pulled out
Resume error 7BH
Executing of dividing process of device detection
of PC card
Initializing COM
Initializing FIR
Resume error when HDD is mounted
DPORT=F172h
(only one time)
2-33