Toshiba QOSMIO E10 Maintenance Manual page 231

4.6 AN board
Installing the AN board
The following describes the procedure for installing the AN board (See Figure 4-11).
1. Connect the wireless LAN antenna cable MAIN (white cable) and SUB (black
cable) to the connectors (PJ9700 and PJ9701) on the AN board.
2. Connect the wireless LAN antenna relay cable MAIN (white cable) and SUB
(black cable) to the connectors (PJ9702 and PJ9703) on the AN board.
3. Install the AN board with the connectors side concealed and secure it with the
following screw.
•
NOTE: After connecting the cables, put the cables into the slot underneath the middle
frame.
4. Install the antenna cable cover and secure it with the following screw.
•
NOTE: When installing the antenna cable cover, be careful not to catch the cables.
QOSMIO E10 Maintenance Manual (960-492)
LH STICK
M2.5×2.8Z BIND screw
4 Replacement Procedures
x1
Slot
x1
4-23