Usb 3.5" Fdd Troubleshooting - Toshiba QOSMIO E10 Maintenance Manual

2 Troubleshooting Procedures
2
2.5

USB 3.5" FDD Troubleshooting

This section describes how to determine if the USB 3.5" FDD is functioning properly.
Perform the steps below starting with Procedure 1 and continuing with the other procedures
as required.
Procedure 1: FDD Head Cleaning Check
Procedure 2: Diagnostic Test Program Execution Check
Procedure 3: Connector Check and Replacement Check
Procedure 1 FDD Head Cleaning Check
FDD head cleaning is one option available in the Diagnostic Program.
Insert the Diagnostics Disk in the floppy disk drive of the computer, turn on the computer
and run the test. And then clean the FDD heads using the cleaning kit. If the FDD still does
not function properly after cleaning, go to Procedure 2.
Detailed operation is given in Chapter 3, Tests and Diagnostics.
If the test program cannot be executed on the computer, go to Procedure 3.
2-36
2.5 USB 3.5" FDD Troubleshooting
QOSMIO E10 Maintenance Manual (960-492)