Toshiba QOSMIO E10 Maintenance Manual page 81

2.4 System Board Troubleshooting
Table 2-6 Debug port (Resume mode) error status (4/4)
LED status
Waiting for the completion of recovery of
VGA register
Recovery of PIT register
Recovery of PCI configuration register
Recovery of PIC MASK
Executing of driver for RESUME
Waiting for the completion of recovery of
FDD
F12Ch
Checks if the power-off switch is pressed
or not during resume processing/
Executes HOTKEY F1 when booting in
instant security
(Not in ACPI mode)
F12Dh
F12Eh (In ACPI mode)
F12Fh
(In ACPI mode)
FFh (In ACPI mode / not in ACPI mode)
QOSMIO E10 Maintenance Manual (960-492)
Test item
2 Troubleshooting Procedures
Contents
Final decision of USB FDD information
After process of PRE_BOOT_SETUP
Clears PWRBTN_STS.
Enables Power Button.
Measures against chip set defective
(models supporting built-in FDD)
Suspends if pressed.
Clears key buffer
Clears IRT status.
Clears flag in Resume process
Acquires Wake Up Vector address.
Clears key buffer.
Renewal of date/time
ACPI mode on
Recovery of write-protected status before.
Initializing printer port
Returning to the main process
2-35