Heatrun Test - Toshiba QOSMIO E10 Maintenance Manual

3.4 Heatrun Test

3.4 Heatrun Test
To execute this program, select 3-Repair heatrun from the startup menu, press Enter.
The heatrun test starts executing automatically as the following order. [FDD read – HDD
read – Memory (read/write/compare) – VRAM]. When the test ends OK/NG message
appears in the display.
NOTE: Make sure the write protection of the Floppy disk is released when executing the
heatrun test. If it is not released, the test can not be executed correctly.
(Example; FDD read test)
When no defective is found, the following message will appear in the display and go to the
next test.
************************************************
************************************************
When a defective is found, the following message will appear in the display and pause to
wait the key input. After pressing any key, it goes to the next test.
************************************************
************************************************
The test executes successively until the VRAM test is finished.
The following message will appear in the display without any defective.
************************************************
************************************************
When a defective is found, ERROR message will appear as above and pause to wait the key
input.
For more details on each test, execute the applicable test in the Diagnostics Test.
QOSMIO E10 Maintenance Manual (960-492)
FDD OK !!
FDD ERROR !!
heatrun test end
3 Tests and Diagnostics
3-11