Toshiba QOSMIO E10 Maintenance Manual page 258

4 Replacement Procedures
Guide
Figure 4-29
Installing the TV tuner module
The following describes the procedure for installing the TV tuner module (See Figure 4-28
and 4-29).
1. Arrange the USB harness along the guide and connect it to the connector CN9501 on
the system board.
NOTE: When arranging the USB harness, TV tuner harness and TV tuner antenna, be
sure to arrange the USB harness first so that USB harness is connected to
CN9501 without mounting on the TV tuner harness.
2. Connect the TV tuner coaxial cable to the connector on the TV tuner module and
arrange it along the guide.
3. Connect the TV tuner harness to the connector on the TV tuner module and arrange it
along the guide.
4. Insert the TV tuner module terminals slantwise into the connector on the system
board and secure it with the following screws.
• B2×4Z
4-50
USB harness
CN9501
Removing the harnesses and coaxial cable
BIND screw x2
QOSMIO E10 Maintenance Manual (960-492)
4.17 TV tuner module
TV tuner harness
TV tuner coaxial cable