Toshiba QOSMIO E10 Maintenance Manual page 222

4 Replacement Procedures
Installing the HDD
The following describes the procedure for installing a HDD (See Figure 4-4 and 4-5).
1. Attach the laminate to the HDD.
2. Install the HDD to the HDD holder and secure them with the following screws.
• F3×4S
NOTE: Although they are 3mm head screws, screw torque must be set in 0.294 N·m
(3.0Kgf·cm) for four screws securing the HDD holder.
3. Insert the HDD assembly into the HDD slot from the screw hole side first and
connect it carefully to the PJ1800 on the system board.
4. Install the HDD slot cover and secure it with the following screw.
• M2.5×10B
4-14
FLAT BIND screw
FLAT BIND screw
QOSMIO E10 Maintenance Manual (960-492)
x4
x1
4.3 HDD