Mdc - Toshiba TECRA M9 Maintenance Manual

4.21 MDC

4.21 MDC
Removing the MDC
The following describes the procedure for removing the MDC. (See Figure 4-33.)
1. Remove the following screws securing the MDC.
• M2×4B
2. Remove the MDC from the connector CN3010 on the system board.
3. Disconnect the MDC cable from the connector on the MDC.
Installing the MDC
The following describes the procedure for installing the MDC. (See Figure 4-33.)
1. Connect the MDC cable to the connector on the MDC.
2. Install the MDC to the connector CN3010 on the system board and secure it with the
following screws.
• M2×4B
TECRA M9 Maintenance Manual (960-631)
BIND screw
Figure 4-33 Removing the MDC
BIND screw
4 Replacement Procedures
×2
M2x4B BIND
MDC cable
MDC
CN3010
×2
[CONFIDENTIAL] 4-49