4 Replacement Procedures
4.3
HDD
Removing the HDD
The following describes the procedure for removing the HDD (See Figure 4-4 and 4-5).
CAUTION: Take care not to press on the top or bottom of the HDD. Pressure may cause
data loss or damage to the device.
1. Turn the computer upside down.
2. Remove the following screw fixing the HDD slot cover and remove the HDD slot
cover.
• M2.5×10B
3. Hold the tab and pull out the HDD assembly from the connector PJ1800 on the
system board.
4-12
FLAT BIND screw
HDD slot cover
Tab
Figure 4-4 Removing the HDD assembly
x1
M2.5x10B FLAT BIND
PJ1800
HDD assembly
QOSMIO E10 Maintenance Manual (960-492)
4.3 HDD