4 Replacement Procedures
4.6
AN board
Removing the AN board
The following describes the procedure for removing the AN board (See Figure 4-11).
1. Remove the following screws and remove the antenna cable cover.
•
2. Remove the following screw fixing AN board and remove the AN board.
•
3. Disconnect the wireless LAN antenna cable MAIN (white cable) and SUB (black
cable) from the connectors (PJ9700 and PJ9701) on the AN board.
4. Disconnect the wireless LAN antenna relay cable MAIN (white cable) and SUB
(black cable) from the connectors (PJ9702 and PJ9703) on the AN board.
Wireless LAN
antenna relay cable
PJ9702
PJ9700
Screw hole
4-22
M2.5×2.8Z
BIND screw
LH STICK
LH STICK
PJ9703
PJ9701
Wireless LAN
antenna cable
AN board
Figure 4-11 Removing the AN board
x1
x1
M2.5x2.8Z BIND
Antenna cable cover
QOSMIO E10 Maintenance Manual (960-492)
4.6 AN board