4.11 SJ board/Microphone
Installing the SJ board
The following describes the procedure for installing the SJ board (See Figure 4-20).
1. Pass through the SJ board flat cable into the slit of the middle frame and arrange it
along the guide while turning up the insulator.
2. Install the SJ board and secure it with the following screw.
• M2×4Z
3. Connect the SJ board flat cable to the connector PJ9560 on the SJ board.
4. Connect the microphone cable to the connector PJ6000 on the SJ board.
QOSMIO E10 Maintenance Manual (960-492)
BIND screw
4 Replacement Procedures
x1
4-37