4.16 Wireless LAN board
4.16
Wireless LAN board
Removing the wireless LAN board
The following describes the procedure for removing the wireless LAN board (See Figure 4-
27).
1. Remove the following screw and remove the Wireless LAN board cover.
(If the wireless LAN board cover is attached.)
• LH STICK
2. Disconnect the wireless LAN antenna relay cable Main (white cable) and AUX
(black cable) from the connectors on the wireless LAN board.
3. Open the left and right latches holding the wireless LAN board and remove it.
LH STICK
Wireless LAN board cover
QOSMIO E10 Maintenance Manual (960-492)
Latch
Figure 4-27 Removing the wireless LAN board
4 Replacement Procedures
x1
Wireless LAN antenna
relay cable (black cable)
Wireless LAN antenna
relay cable (white cable)
AUX
MAIN
4-47