Fluorescent Lamp - Toshiba QOSMIO E10 Maintenance Manual

4.25 Fluorescent Lamp

4
4.25 Fluorescent lamp
This system uses LCD module from the following supplier.
Type Part No.
15.0 inch
G33C00024110
(XGA)
NOTE: - When working with a LCD module, always use a flat, grounded table.
- Handle the backlight unit in the environment without dust, such as on the clean
bench. Keep the worktable free from any screws or other material that may
scratch the LCD surface.
- Use an anti-static or protective sheet.
- When replacing the FL unit, cover with a finger protector or similar to prevent
dirtying or scratching the LCD panel.
- Take care when handling the lamp. Excessive force may break the lamp.
- Take care not to dirty or deform the lamp reflector.
- Ensure always that the power of the LCD module is turned off before
connecting or disconnecting cables and connectors.
QOSMIO E10 Maintenance Manual (960-492)
Supplier
Sharp
4 Replacement Procedures
Section
4.25.1
4-71