Toshiba QOSMIO E10 Maintenance Manual page 75

2.4 System Board Troubleshooting
Table 2-5 Debug port (Suspend mode) error status (1/3)
D port status
Sets the parallel port to D0 state
(PRT support model)
F130h Release resources used for identification of
fingerprint. (For model supporting the
fingerprint identification)
F131h When powering-off request from OS is
required, waiting for the completion of dividing
process because waiting in SUSPEND of
Runtime returns the process to OS.
Forced execution of dividing (Permission of
SMI for dividing)
Waiting for completion of dividing
F132h After prohibiting of all SMI, permits I/O
trap(EHCI) and external SMI.
Starts dividing to transmit periodically
extension command (every 25 seconds) not to
generate time-out of power-off.
Clears resume/power-off status.
Storing and initializing of special configuration
register
Prohibits clock control.
Recognition of suspending for boot/ resume
Branch of resume mode
(DPORT=F133h/F132h) or boot
mode(DPORT=F134h/F133h)
F133h Powering-off during resuming
Resume error check in suspend mode.
F134h
Execution of driver for suspend
Clearing of data for Remote Lockout
Storing of FDD register
Storing of USB register
Halt of HC.
QOSMIO E10 Maintenance Manual (960-492)
Inspection items
2 Troubleshooting Procedures
Details
Halts HC.
If in password process, recovers display
information.
Starts sequence for storing display system.
Checks if in IRT.
Checks if external cards are connected (If PNP
OS exists, does not check.)
(Models supporting built-in FDD)
2-29