4 Replacement Procedures
4.8
Optical drive
This section describes how to remove and install the Optical drive.
NOTE: Do not apply excessive force to the top of an optical drive.
Do not touch the shaded portion of the figure below, when the drive is removed
or installed.
Removing the optical drive
The following describes the procedure for removing the optical drive (See Figure 4-13 and 4-
14).
1. Turn over the computer and remove the following screws securing the optical drive
assembly.
•
2. Pull out the optical drive assembly towards the arrow direction to disconnect it from
the PJ1820 on the system board.
NOTE: When it is difficult to pull out the optical drive assembly, insert your finger into
the slot and push out the optical drive assembly.
4-26
M2.5×4B FLAT BIND screw
x2
QOSMIO E10 Maintenance Manual (960-492)
4.8 Optical drive