Mitsubishi Electric FR-F820-00077 Instruction Manual page 778

Ethernet communication (FR-F800-E)
The signal within parentheses ( ) is the initial status. The input signal function can be changed using
Pr. 180 to Pr. 189 (input terminal function selection) (page 5-285).
JOG operation/automatic restart after instantaneous power failure/start self-holding selection/
reset cannot be controlled over a network, so in the initial status bit 6, bit 9, bit 11, and bit 12 are
invalid. To use bit 6, bit 9, bit 11, and bit 12, change the signal by Pr. 185, Pr.186, Pr. 188, or Pr. 189.
The inverter run enable signal is in the initial status for the separated converter type.
The signal within parentheses ( ) is the initial status. The output signal function can be changed
using Pr. 190 to Pr. 196 (output terminal function selection) (page 5-231).
No function is assigned in the initial status for the separated converter type.
Tab. 5-323: Operation mode/inverter setting
Enable/disable parameter writing by Pr. 79 and Pr. 340 settings. For the details, refer to page 5-128.
Restrictions in each operation mode conform with the computer link specification.
● Real-time monitor
Refer to the description of Pr. 52 on page 5-198 for the register numbers and monitored items of
the real time monitor.
5 - 606
Mode
EXT
PU
EXT JOG
PU JOG
NET
PU+EXT
Read value
H0000
H0001
H0002
H0003
H0004
H0005
Parameters
Write value
H0010
H0011
⎯
⎯
H0014
⎯