Mitsubishi Electric FR-F820-00077 Instruction Manual page 377

Parameters
Displaying the set frequency during stop (Pr. 52)
When Pr. 52 = "100", the set frequency is displayed during stop, and output frequency is displayed
during running. (LED of Hz flickers during stop and is lit during operation.)
Pr. 52 setting
0
100
Tab. 5-88:
Displays the frequency that is output when the start command is ON. The value considers the
maximum/minimum frequency and frequency jumps. It is different from the frequency setting
displayed when Pr. 52 = "5".
NOTES During an error, the output frequency at error occurrence appears.
During output shutoff by the MRS signal, the values displayed are the same as during a stop.
During offline auto tuning, the tuning state monitor takes priority.
Operation panel setting dial push display (Pr. 992)
● Use Pr. 992 to select the monitor that appears when the setting dial on the operation panel
(FR-DU08) is pushed.
● When Pr. 992 = "0 (initial value)", keep pressing the setting dial when in PU operation mode or
External/PU combined operation mode 1 (Pr. 79 "Operation mode selection" = "3") to show the
presently set frequency.
● When Pr. 992 = "100", the set frequency is displayed during stop, and output frequency is displayed
during running.
Pr. 992 setting
0
100
Tab. 5-89:
Displays the frequency that is output when the start command is ON. The value considers the
maximum/minimum frequency and frequency jumps. It is different from the frequency setting
displayed when Pr. 992 = "5".
FR-F800
Output
Status
frequency
During running/
Output frequency
stop
During stop
Set frequency
Running Output frequency
Display during running and stop
Status
During running/stop
During stop
Running
Display, when the setting dial is pushed
(M) Monitor display and monitor output signal
Output current Output voltage
Output current Output voltage
Monitor displayed by the setting dial push
Set frequency (PU direct-in frequency)
Set frequency
Output frequency
Fault or alarm
indication
Fault or alarm
indication
5 - 205