Mitsubishi Electric FR-F820-00077 Instruction Manual page 685

Parameters
Object
identifier
321
322
398
399
10007
10008
Tab. 5-267: Object assignment for analog values (2)
R: Read only,
W: Read/Write (Commandable values not supported),
C: Read/Write (Commandable values supported)
Values written to the objects that support the commandable values are stored in the Priority Array,
even when "Write Access Denied" is returned due to inconsistency of the writing requirements
such as the operating mode, on condition that the values are written within the setting range.
If communication speed command source is other than NET, the setting value can be written, but
not to be applied.
When both C42 (Pr. 1136) and C44 (Pr. 1138) ≠ "9999", the setting range is from the smaller
coefficient to the larger coefficient of C42 (Pr. 1136) and C44 (Pr. 1138). Depending on the setting,
the writing value and the reading value may not be the same at the minimum digit.
FR-F800
Present value
Object name
access type
Second PID
measured value C
CMD
Second PID
C
deviation CMD
Mailbox
W
parameter
Mailbox value W
Acceleration
W
time
Deceleration
W
time
(N) Operation via communication and its settings
Description
Set the second PID measured value.
This object is the measured value during PID
operation if Pr. 753 = "60 or 61".
(Setting range: 0.00 to 100.00)
Set the second PID deviation. (0.01 increment)
This object is the deviation during PID
operation if Pr. 753 = "50 or 51".
(Setting range: -100.00 to 100.00)
Access to the properties which are not defined
as objects are available (refer to page 5-516).
Sets Pr. 7 "Acceleration time"
Sets Pr. 8 "Deceleration time"
Unit
no-units (95)
percent (98)
no-units (95)
no-units (95)
seconds (73)
seconds (73)
5 - 513