Mitsubishi Electric FR-F820-00077 Instruction Manual page 372

(M) Monitor display and monitor output signal
Types of
monitor
Actual operation
time
Motor load
factor
Cumulative
power
Motor output
Trace status
PLC function
user monitor 1
PLC function
user monitor 2
PLC function
user monitor 3
Station number
(RS-485
terminals)
Station number
(PU)
Station number
(CC-Link)
Energy saving
effect
Cumulative
energy saving
PID set point
PID measured
value
PID deviation
Input terminal
status
Output terminal
status
Tab. 5-87:
5 - 200
Pr. 52,
Unit Pr. 774 to Pr. 776,
Pr. 992
1 h 23
0.1% 24
0.01 kWh/
0.1 kWh 25
0.01 kW/
34
0.1 kW
1 38
40
41
Accord-
ing to the
SD1215
setting
42
1 43
1 44
1 45
50
Changea-
ble by pa-
rameter
51
setting.
0.1% 52
0.1% 53
0.1% 54
—
55
—
Monitor description list (2)
RS-485
communica- MODBUS®
tion dedicat- RTU real Minus (-)
ed monitor time display
(hexadeci- monitor
mal)
H17 40223
H18 40224
H19 40225
H22 40234
H26 40238
H28 40240
H29 40241
H2A 40242
H2B 40243
H2C 40244
H2D 40245
H32 40250
H33 40251
H34 40252
H35 40253
H36 40254
H0F 40215
H10 40216
Parameters
Description
Displays the cumulative time
since the inverter began running.
The number of times the monitor
value exceeded 65535 h can be
checked with Pr. 564.
This can be cleared with Pr. 171.
(Refer to page 5-207)
Displays the output current
value as a percentage,
considering the inverter rated
current value as 100%.
Monitor value = output current
monitor value / inverter rated
current × 100 [%]
Displays the cumulative energy
based on the output power
monitor.
This can be cleared with Pr. 170.
(Refer to page 5-207.)
Multiplies the output torque at
that time with the motor speed,
and displays the machine output
for the motor shaft end.
Displays the trace status.
(Refer to page 5-443)
Displays the arbitrary monitoring
item using the PLC function.
Displays the following special
register values.
SD1216: Displays in No. 40
SD1217: Displays in No. 41
SD1218: Displays in No. 42
(Refer to the PLC Function
Programming Manual.)
Displays which station number (0
to 31) can currently be used for
communication from the RS-485
terminal block.
Displays which station number (0
to 31) can currently be used for
communication from the PU
connector.
Displays which station number (0
to 31) can currently be used for
CC-Link communication.
Displays "0" when the FR-A8NC is
not connected.
Displays the energy saving effect
monitor.
Conversion to power saving,
average power saving, price
display, and percentage display
can be done using parameters.
(Refer to page 5-60.)
Displays the set point, measured
value, and deviation under PID
control.
(Refer to page 5-368)

Displays input terminal ON/OFF
state of the inverter. (Refer to
page 5-206 for DU display.)
Displays output terminal ON/OFF
state of the inverter. (Refer to
page 5-206 for DU display.)