Mitsubishi Electric FR-F820-00077 Instruction Manual page 443

Parameters
· Adjust any point without application of a voltage (current) between terminals 2 and 5 (4 and 5)
(Frequency setting gain adjustment example)
Screen at power-ON
The monitor display appears.
Changing the operation mode
Press
Parameter setting mode
Press
Calibration parameter selection
Turn
Selecting the parameter number
Turn
and "
Analog voltage (current) display
Press
Analog voltage (current) adjustment
When
When
Setting completed
Press
alternately.
Turn
Press
Press
Tab. 5-117: Bias and gain adjustment without application of an reference signal
NOTE By pressing the setting dial after step
confirmed. Confirmation is not possible after executing step
FR-F800
to choose the PU operation mode. [PU] indicator is lit.
to choose the parameter setting mode. (The parameter number read previously appears.)
until " " appears. Press
to choose " " C4 (Pr. 903) "Terminal 2 frequency setting gain" for the terminal 2.
" C7 (Pr. 905) "Terminal 4 frequency setting gain" for the terminal 4.
to display the analog voltage (current) % currently applied to the terminal 2 (4).
is turned, the gain voltage (current) % currently set to the parameter is displayed.
until the desired gain voltage (current) % is displayed.
to enter the setting. The analog voltage (current) % and "
to read another parameter.
to return to the "
twice to show the next parameter.
(T) Multi-Function Input Terminal Parameters
Operation
to display "
" display.
, the present frequency setting bias/gain setting can be
".
( )" flicker
.
5 - 271