Mitsubishi Electric FR-F820-00077 Instruction Manual page 393

Parameters
Calibration procedure for terminal FM when using the operation panel (FR-DU08)
Screen at power-ON
The monitor display appears.
Changing the operation mode
Press
Calibration is also possible in the External operation mode.
Parameter setting mode
Press
Calibration parameter selection
Turn
Selecting the parameter number
Turn
parameter setting. The monitored value of the item (initially the output frequency) selected by Pr. 54 "FM/CA terminal
function selection" will appear.
Pulse output via terminal FM
If stopped, press
connection is not required.
When a monitor that does not require inverter operation is set in Pr. 54, calibration is also possible during a stop status.
Scale adjustment
Turn
Setting completed
Press
Turn
Press
Press
Tab. 5-98:
NOTES Calibration can also be made for the External operation.Set the frequency in the External opera-
tion mode, and make calibration in the above procedure.
Calibration can be performed during operation.
For the operation from the parameter unit, refer to the Instruction Manual of the parameter unit.
FR-F800
to choose the PU operation mode. [PU] indicator is lit.
to choose the parameter setting mode. (The parameter number read previously appears.)
until " " appears. Press
until " " (C0 (Pr. 900) FM/CA terminal calibration) appears. Press
or to start the inverter operation. (To monitor the output frequency, motor
to move the meter needle to a desired position.
to enter the setting. The monitored value and "
to read another parameter.
to return to the "
twice to show the next parameter.
FM terminal calibration
(M) Monitor display and monitor output signal
Operation
to display "
" display.
".
to enable the
" flicker alternately.
5 - 221