Interface Mode - Avaya P333R User Manual

Interface Mode

ip bootp-dhcp server Command
Use the ip bootp-dhcp server command to add a bootp/dhcp server to
handle bootp/dhcp requests received by this interface. The no form of this
command removes the server. A maximum of two servers can be added to a single
interface.
The syntax for this command is:
ip bootp-dhcp server <ip-address>
ip-address
Example:
To add station 192.168.37.46 as a bootp/dhcp server to handle bootp/dhcp requests
arriving at the interface "marketing":
Router-N(config-if:marketing)# ip bootp-dhcp server
192.168.37.46
ip bootp-dhcp network Command
Use the ip bootp-dhcp network command to select the network from which
the bootp/dhcp server shall allocate an address. This command is required only
when there are multiple interfaces over the VLAN. The no form of this command
restores to the default.
The syntax for this command is:
[no] ip bootp-dhcp network <ip-address>
ip-address
Example:
To select the network 192.168.169.0 as the network from which an address shall be
allocated for bootp/dhcp requests:
Router-N(config-if:marketing)# ip bootp-dhcp network
192.168.169.0
Avaya P333R User's Guide
Chapter 7
The IP address of the server.
The IP address of the network.
Cajun Campus CLI - Layer 3
205