Table of Contents
Advertisement
Chapter 5
CLI – Layer 2
• copy tftp module-
config
• copy tftp
EW_Archive
• copy tftp
SW_image
• radius
authentication
1 The clear command corresponds to a group of commands and is
shown in a separate Table on Page 80.
2 The set command corresponds to a group of commands and is shown
in a separate Table on Page 84.
3 The radius authentication commands corresponds to a group
of commands listed on Page 131.
no hostname
Use the no hostname command to return the module CLI prompt to its default.
The syntax for this command is:
no hostname
Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.
no rmon history
Use the no rmon history command to delete an existing RMON history entry.
The syntax for this command is:
no rmon history <History Index>
no rmon alarm
Use the no rmon alarm command to delete an existing RMON alarm entry.
The syntax for this command is:
no rmon alarm <Alarm Index>
78
Downloads a switch configuration file
(using TFTP).
Downloads the Device Manager S/W
(Embedded Web Archive file), using
TFTP, into the device.
Updates the software image and device
manager application of a designated
switch.
Sets radius authentication parameters.
3
Page 129
Page 129
Page 130
Page 131
Avaya P333T-PWR User's Guide
Advertisement
Table of Contents
