Table 2.1 Avaya P333R Led Descriptions - Avaya P333R User Manual

Chapter 2 Avaya P333R Front and Rear Panels
Note: All LEDs are lit during a reset.
Table 2.1
LED Name
PWR
OPR
SYS
ROUT
The following Function LEDs apply to ports 1 to 40
LNK
COL
Tx
20
Avaya P333R LED Descriptions
Description
Power Status
CPU Operation
System Status
Routing Mode
Port Status
Collision
Transmit to line
LED Status
OFF – Power is off
ON – Power is on
Blink – Using BUPS only
OFF – Module is booting
ON – Normal operation
OFF – Module is a slave in a stack
ON – Module is the master of the stack and
the Octaplane and Redundant cable are
connected correctly.
This LED will also light in Standalone mode.
Blink – Box is the master of the stack and the
stack is in redundant mode
OFF – Layer 2 only
ON – Router and Layer 2
Blink – EZ2route and Layer 2
OFF – Port disabled
ON – Port enabled and link OK
Blink – Port enabled and the link is down
OFF – No collision or FDX port
ON – Collision occurred on line
OFF – No transmit activity
ON – Data transmitted on line from the
module
Avaya P333R User's Guide