Creating A Shotbox Register Using The Menus - Sony MVS-3000 System User Manual

To recall an assigned effect and simultaneously
execute it
Press the [AUTO RUN] button, lighting it green, then save
the shotbox register.
Creating a Shotbox Register using
the Menus
1
Open the Shotbox >Register >Store/Recall menu
(6411).
In the status area, the settings for each register appear
as follows.
Region settings: Appear as "Sxxx" when a snapshot is
allocated, and as "Exxx" when an effect is
allocated (where xxx is the register number). The
register name also appears. If nothing is allocated,
nothing appears in the display.
Register lock setting: When the register is write-
protected, an "L" (for "lock") appears.
Empty status: When the register is empty, an "E" (for
"empty") appears.
Auto run setting: When this is enabled, so that an
effect is executed simultaneously with recall,
"AR" appears.
Shotbox register name: This shows the shotbox
register name.
2
If necessary, press one of the following buttons in the
status area to change the region display.
M/E, P/P: Indicates assignment of M/E-1 (ME1), P/P
(P/P).
User: Shows the allocations for User 1 (USR1) to User
8 (USR8).
DEV1-8: Shows the allocations for Device 1 (DEV1)
to Device 8 (DEV8).
DEV9-12: Shows the allocations for Device 9 (DEV9)
to Device 12 (DEV12).
Misc: Shows the allocations for P-Bus (PBUS), GPI
(GPI), Router (RTR), and Macro (MCRO).
3
Select a register.
4
Press [Edit].
178
Shotbox Register Creation
The Edit menu (6411.1) appears.
You can also use the [Shotbox Reg] parameter to
select the register in this menu.
In the status area, the shotbox register status for each
region appears.
5
Select a region.
You can select more than one region.
To select all regions, press [ALL]. To select all
switcher-related regions (M/E, P/P, User), press [SWR
ALL].
6
In the <Assign> group, select the snapshot or effect to
be allocated to the region.
Snapshot: Allocate a snapshot.
Effect: Allocate a keyframe effect.
If the selected register is locked, a confirmation
message appears asking whether or not to cancel the
operation. Press [OK] to return to the previous menu
display without carrying out the registration.
If the operation is carried out, the region selected in
step 5 is registered in the shotbox, and the parameters
are now valid.
7
Depending on the selection in step 6, set the following
parameters.
When a snapshot is selected
No. Parameter Adjustment
3 Snapshot Snapshot register number
When an effect is selected
No. Parameter Adjustment
3 Effect Keyframe effect register number
8
To run the allocated effect as soon as it is recalled,
press [Auto Run], turning it on.
9
Repeat steps 5 to 8 as required.
10
In the <Store> group, press [Store] to save the setting.
To return to the state before saving the setting
In the <Store> group, press [Undo].
To execute the settings to check them
Press [Recall] to execute the shotbox.