Hitachi WJ200-001S Instruction Manual page 672

Special monitor display (-S--, -F**) cancellation
The parameter of b147 can be used to select whether special monitor display is canceled temporarily by
・
pressing down a key on the keypad during special monitor display (-S--, -F**) is displayed. Please refer to
table Ver.3.1-5 for details of special monitor display.
In the case of b147=00 (Cancellation of special display is invalid) setting, key operation is not accepted at all,
・
and special monitor display (-S--, -F**) is kept on being displayed.
In the case of b147=01 (Cancellation of special display is valid) setting, special monitor display is canceled
・
temporarily by pressing a key on the keypad and then normal display (parameter display) is displayed.
After having canceled special monitor display, it returns to an original special monitor display content if no
・
key operation has been done for the time specified by b148 (Special monitor display re-display time). If
content of special monitor display is changed due to transition of signal status, it displays corresponding
special monitor display content immediately regardless of the cancellation time. (e.g.: change into "-F**"
state from "-S--" state)
b148 can adjust the time to re-display special monitor display after it has been cancelled. Special display is
・
displayed again after passing time specified by b148 from the last key operation.
Func. Func. Func. Func.
Name Name Name Name
Code Code
Code Code
b147 b147 Special monitor display
b147 b147
cancellation
Special monitor display
b148 b148 b148 b148
re-display time
Increase of upper limit up of BRD Activation Level
The upper limit of b096 "BRD Activation Level" of 200V and 400V class are increased by 10V and 20V
・
respectively.
Func. Func. Func. Func.
Name Name Name Name
Code Code
Code Code
b096 b096 BRD activation level
b096 b096
Table Ver.3.1-6
Description Description Description Description
00...Cancellation of special display 00
00 00
is invalid
0 0 0 0 1 1 1 1 ...Cancellation of special display
is valid
Time to return to special display,
range is 1 to 30 sec.
Table Ver.3.1-7
Description Description Description Description
When internal DC voltage exceeds
the specified level, BRD circuit is
activated. When internal DC
voltage falls below the level, BRD
circuit is inactivated.
(Ver. 3.0 or before)Range is:
330 to 380 V (200V class)
660 to 760 V (400V class)
(Ver. 3.1 or after)Range is:
330 to 390 V (200V class)
660 to 780 V (400V class)
Modbus register Modbus Modbus Modbus register register register
A A A A B B B B Initial data Initial data Initial data Initial data
number number
number number
01 13d0h
30 13d1h
Modbus register Modbus Modbus Modbus register register register
A A A A B B B B Initial data Initial data Initial data Initial data
number number
number number
360/ 1363h
720
Ver.3.1− − − − 7
Resolution Resolution Resolution Resolution
-
1 [sec]
Resolution Resolution Resolution Resolution
1 [V]