Hitachi WJ200-001S Instruction Manual page 316

Error
Code
Rotating






Blinking


Reset is not allowed in 10 second after trip.
NOTE:
When error E08, E14 and E30 occur, reset operation by RS terminal or STOP/RESET
NOTE:
key is not accepted. In this case, reset by cycling power. If still same error occurs, perform
initialization.
Warning Codes
If set parameter is conflicted to other parameters, warning code is displayed as follows.
Warning
Code

Frequency upper limit ()

Frequency lower limit ()
Output Frequency setting ()

Multi-speed freq. 0 ()
Output Frequency setting ()

Multi-speed freq. 0 ()

Frequency lower limit ()
 Start frequency ()

Start frequency ()

Start frequency ()
 Start frequency ()

Start frequency ()
Name

Reset
Undervoltage
Waiting to restart
Restricted operation
command
Trip history
initializing
No data
(Trip monitor)
Communication
error
Auto-tuning
completed
Auto-tuning error
Descriptions
RS input is ON or STOP/RESET key is pressed.
If input voltage is under the allowed level, inverter
shuts off output and wait with this indication.
This indication is displayed after tripping before
restarting.
Commanded RUN direction is restricted in b035.
Trip history is being initialized.
No trip/waning data exists.
Communication between inverter and digital
operator fails.
Auto-tuning is completed properly.
Auto-tuning fails.
Warning condition
>
Max. Frequency ()
>
Max. Frequency ()
>
Max. Frequency ()
>
Frequency upper limit ()
Output Frequency setting ()
>
Multi-speed freq. 0 ()
> Frequency upper limit ()
>
Frequency lower limit ()
Output Frequency setting ()
>
Multi-speed freq. 0 ()
> Multi-speed freq. 1-15 (-)
>
Jogging frequency ()
611