Hitachi WJ200-001S Instruction Manual page 398

Func.
Name
Code
Calculation symbol
A143
ADD frequency
A145
ADD direction select
A146
Curvature of EL-S-curve at
a150
the start of acceleration
Curvature of EL-S-curve at
a151
the end of acceleration
Curvature of EL-S-curve at
a152
the start of deceleration
Curvature of EL-S-curve at
a153
the end of deceleration
Deceleration hold frequency
a154
Deceleration hold time
a155
PID sleep function action
a156
threshold
PID sleep function action
a157
delay time
[VR] input active range start
A161
frequency
[VR] input active range end
A162
frequency
[VR] input active range
A163
start %
"A" Function
Description
Calculates a value based on the
A input source (A141 selects)
and B input source (A142
selects).
Three options:
00...ADD (A input + B input)
01...SUB (A input - B input)
02...MUL (A input * B input)
An offset value that is applied
to the output frequency when
the [ADD] terminal is ON.
Range is 0.0 to 400.0 Hz
Two options:
00...Plus (adds A145 value to
the output frequency
setting)
01...Minus (subtracts A145
value from the output
frequency setting)
Range is 0 to 50%
Range is 0 to 50%
Range is 0 to 50%
Range is 0 to 50%
Sets the frequency to hold
deceleration, range is 0.0 to
400.0Hz
Sets the duration of
deceleration hold, range is 0.0
to 60.0 seconds
Sets the threshold for the
action, set range 0.0 to 400.0
Hz
Sets the delay time for the
action, set range 0.0 to 25.5 sec
The output frequency
corresponding to the analog
input range starting point,
range is 0.0 to 400.0 Hz
The output frequency
corresponding to the current
input range ending point,
range is 0.0 to 400.0 Hz
The starting point (offset) for
the current input range,
range is 0. to 100.%
C− − − − 11
Run
Mode Defaults
Edit
A B Initial data Units
00
−
0.00 Hz
00
−
10. %
10. %
10. %
10. %
0.00 Hz
0.0 sec.
0.00 Hz
0.0 sec
0.00 Hz
0.00 Hz
0. %