Restoring Factory Default Settings - Hitachi WJ200-001S Instruction Manual

614

Restoring Factory Default Settings

You can restore all inverter parameters to the original factory (default) settings
according to area of use. After initializing the inverter, use the powerup test in Chapter
2 to get the motor running again. If operation mode (std. or high frequency) mode is
changed, inverter must be initialized to activate new mode. To initialize the inverter,
follow the steps below.
(1) Select initialization mode in .
(2) If =,
(3) If =,
(4) Set

(5) The following display appears for a few seconds, and initialization is completed with

Display during initialization
Initialization
mode
Operation
mode after
initialization
mode
Func.
Code
Initialization mode

(parameters or trip
history)
Initialization target

data setting
Initial value select

Initialization trigger

Data of b084 is not saved in EEPROM to avoid unintentional initializing.
or , select initialization target data in .

or , select country code in .

in .
displayed.



The left digit rotates during initialization
Blinking alternately


 
Name
Select initialized data, five option codes:
Initialization disabled
Clears Trip history
Initializes all Parameters
Clears Trip history and initializes all parameters
Clears Trip history and initializes all parameters and EzSQ
program
Select initialized parameters, four option codes:
All parameters
All parameters except in/output terminals and communication.
Only registered parameters in xxx.
All parameters except registered parameters in
Select default parameter values:
area A
This is to perform initialization by parameter input with ,
and . Two option codes:
Initialization disable
Perform initialization
Initialization of trip history
Initialization for area A
Initialization for area B
HD mode
ND mode
PM mode
"B" Function
Description
area B

and .
xxx
