Hitachi WJ200-001S Instruction Manual page 276

Positioning Completion Signal
Inverter gives out the positioning signal when positioning performance is done.
To use this function, assign
Refer to chapter 4 for the details of the performance.
Option Terminal
Code Symbol

POK Positioning
completion signal
11, 12, AL0 – AL2
Valid for inputs:
~
Required settings
Notes:
 The example circuit for terminal [11] drives a relay
coil. Note the use of a diode to prevent the
negative-going turn-off spike generated by the coil
from damaging the inverter's output transistor.
" (POK)" to one of the intelligent output terminals.
Function Name State
ON
OFF
Description
Positioning performance is completed
Positioning performance is not completed
Example for terminal [11] (default output
configuration shown – see
Inverter output
terminal circuit
CM2
Example for terminal [AL0], [AL1], [AL2] (requires
output configuration – see
Inverter logic
circuit board
AL0 AL1
Power
supply
See I/O specs on page 4-6
469
page 3-89):
POK
11
RY
page 4-51 and 3-91):
POK
AL2
Load