Hitachi WJ200-001S Instruction Manual page 421

D− − − − 2
CE-EMC Installation Guidelines
You are required to satisfy the machinery directive (2006/42/EC) and the EMC directive
(2004/108/EC [until April 19
inverter in an EU country.
To satisfy the EMC directive and to comply with standard, you need to use a dedicated EMC
filter suitable for each model, and follow the guidelines in this section. Following table shows
the compliance condition for reference.
Input class
1-ph. 200V class
3-ph. 200V class
3-ph. 400V class
WJ200-110L and 150H needs to be installed in a metal cabinet and add ferrite core
at the input cable to meet category C1. Unless otherwise category C2.
Important notes
1. 1. 1. 1. Input choke or other equipment is required if necessary to comply with EMC
directive from the harmonic distortion point of view (IEC 61000-3-2 and 4).
2. 2. 2. 2. If the motor cable length exceeds 20m, use output choke to avoid unexpected
problem due to the leakage current from the motor cable (such as malfunction of
the thermal relay, vibration of the motor, etc..).
2016], 2014/30/EU [from April 20
th
Table 1. Condition for the compliance
Model
All WJ200 series
Table 2. Applicable EMC filter
Inverter model
WJ200-001SFE
WJ200-002SFE
WJ200-004SFE
WJ200-007SFE
WJ200-015SFE
WJ200-022SFE
WJ200-001LFU
WJ200-002LFU
WJ200-004LFU
WJ200-007LFU
WJ200-015LFU
WJ200-022LFU
WJ200-037LFU
WJ200-055LFU
WJ200-075LFU
WJ200-110LFU
WJ200-150LFU
WJ200-004HFE
WJ200-007HFE
WJ200-015HFE
WJ200-022HFE
WJ200-030HFE
WJ200-040HFE FS24830-15-07
WJ200-055HFE
WJ200-075HFE
WJ200-110HFE
WJ200-150HFE
Cat. Carrier f
C1 2kHz
Filter model (Schaffner)
FS24828-8-07
FS24828-27-07
FS24829-8-07
FS24829-16-07
FS24829-25-07
FS24829-50-07
FS24829-70-07
FS24829-75-07
FS24830-6-07
FS24830-12-07
FS24830-29-07
FS24830-48-07
2016]) when using a WJ200
th
Motor cable
20m (Shielded)