Kodak DryView 8300 Service Bulletins page 76

2-10. Connecting the 9410 to Power
1. Set the Voltage Selection Switch on the 9410 as instructed in paragraph 3-8-5 in the 9410 Service
Manual.
2. Set up the Uninterruptable Power Supply and connect the 9410 to power as instructed in paragraph
3-8-6 of the 9410 Service Manual.
3. Apply power to the 9410.
2-11. Connecting the 9410 to the DICOM Network
1. Obtain the required network parameters and ID information from the network administrator as
instructed in paragraph 3-4 of the 9410 Service Manual.
2. Access the 9410 for service as instructed in paragraph 3-10 of the 9410 Service Manual.
3. Start up the system (paragraph 3-10-3-3).
4. Enter the customer network parameters into the 9410 (paragraph 3-10-3-6) and into your Service PC
(paragraph 3-10-3-7).
2-12. Configuring the 9410 for Local Printing (COPCIL Setup)
Refer to paragraph 3-15-1 in the PACS Link 9410 Service Manual for instructions for configuring the 9410
to send images to the 8600/8610 for printing. The 9410 parameters must be set to the following values:
Printer and Connection Identification Parameters:
Printer Name = 8600 or 8610
Model = 8600/8610
Manufacturer = Imation
Output Board = Copper
Communication Parameters:
Command Set = 952
Baud Rate = 1200
Data Bits = 8
Stop Bits = 1
Parity = Even
Image Transfer Parameters:
Pixel Depth = 8 for 8600, 12 for 8610
Header Mode = Header
Acquire Mode = Line
Acquire Timeout = 90
Transfer Rate = 2 MHz
Default Parameters:
Film Mismatch = Print Always
Interpolation Type = Imation 831
Interp Num = 1
Installed TFT/ULUT (Not configurable for the 8600/8610.)
Max Density = 350
Contrast = Varies with the modality. See Table 2-4.
Border Density = 4095
TFT/ULUT Emulation (Unchecked)
2000 December Rev. B
Section 2 - - Installation
2-7