Kodak DryView 8300 Service Bulletins page 128

Procedure
The procedure in the SERVICE MANUAL and the Mod 1 instructions refer to installing software
upgrades when using HyperTerminal software that is resident in the Windows OPERATING
SYSTEMS (OS). While HyperTerminal software is adequate for SERVICE COMPUTERS using the
Windows 95 or 98 OS, the download process is too slow when using the software with Windows NT
OS or Windows 2000 OS. Users of Windows NT OS and Windows 2000 OS must use more
sophisticated software such as ProComm Plus to be able to download the IMAGER system software
in less than one half hour. If ProComm Plus is used, follow these setup instructions:
• Launch ProComm Plus
• In the Options pull-down menu, select System Options, followed by Modem Connection.
• Find the Current Modem/Connection: pull-down menu and then select "direct connect-
Com1"
• Click on Modem/Connection Properties... button and then make the following selections:
o Baud rate: = 38400
o Parity: = None
o Data bits: = 8
o Stop bits: = 1
o Check only the box for: Use software flow control
o Click on OK to close the Modem/Connection Properties window.
• Click on OK again to close the (Options) Setup window.
To start the download, click on the Send File icon, browse the file names provided in the Mod 1
modification instructions and continue with the rest software installation.
Page 3 Pub No. 8E9726