Kodak DryView 8300 Service Bulletins page 66

Problem
Artifacts repeating down length
of film, recurring every 2 - 3
inches.
An * is printed in the lower right
corner of image.
Films are discolored on the
edges.
Image fades out down one side
of the entire film.
Image fades out down both
sides of entire film.
Double or super imposed
images.
8-2. Miscellaneous Problems
Problem
The DryView 8600 stops
printing, but the display says
"Printing" with no error
message.
A TO D CONVERTER
FAILURE error message
appears when Processor
Assembly is opened.
The density or contrast of 8600
internal SMPTE test pattern
images is different from test
pattern images sent from the
9410.
Film stops in the processor
(may be accompanied by
EC 27).
Cause
A piece of debris is attached to
one of the capstan pinch
rollers, interrupting the laser
beam.
The image was manipulated by
the 8600 to fit in the printable
area of the film.
Imager has been installed near
a wet processor.
Laser diode or mirror in Optics
Module has become
mis-aligned.
Thermofuse has blown in the
series-wired end zone circuit.
Defective memory module.
Cause
Defective CPU PWA.
Grounding clip used to ground
backup roller assemblies is not
seated firmly against mounting
screw.
The internal SMPTE test
pattern uses the density and
contrast selected on the Local
Panel. If the density and
contrast settings in the 9410 (or
modality) are different, they will
override the 8600 settings.
A white glaze has built up on
entrance and exit rollers of
processor.
Solution
Clean the capstan rollers with
alcohol and a lint-free cloth.
Advise operator that the image
sent is too large to fit on the
film and that it has been
minified. Ensure that the
Detector Size setting in the
8600 matches the modality's
detector size.
Inform customer that imager
cannot be in the same area as
a wet processor.
Replace Optics Module.
Replace thermofuse in drum.
Replace SIMMs.
Solution
Replace CPU PWA.
Check and reseat, if necessary,
both grounding clips (one on
each side of the Processor
Assembly).
Ensure that the 8600 Local
Panel density and contrast
settings are the same as those
set in the 9410 (or modality).
Clean rollers with alcohol and
wipes.